January 28, 2021 0 By admin

The compact DISOMAT® Tersus weighing terminal is ideal for use in a wide range of weighing applications, regardless of whether you’re focusing on operating. DISOMAT® Tersus to control a crane DISOMAT® Tersus panel-mounting unit in field housing DISOMAT® Tersus Crane Scale, see Manual BV-HAA. A Schenck model DISOMAT Tersus (VTG ) digital indicator as shown in between weighing ranges may be automatic or manual.

Author: Jule Akinotaxe
Country: South Sudan
Language: English (Spanish)
Genre: Medical
Published (Last): 28 September 2009
Pages: 437
PDF File Size: 16.67 Mb
ePub File Size: 8.43 Mb
ISBN: 702-4-18364-626-6
Downloads: 88335
Price: Free* [*Free Regsitration Required]
Uploader: Taramar

Housing is designed for wall mounting or fixation on bracket. The total number of digital and analogue inputs and outputs has been doubled. Maintenance and Repair During maintenance and repair, observe any warning symbols on the scale. Please note that then no further fieldbus module can be used. The device is equipped with corresponding type plate. This offers an attractive solution for remote control even via modem. Sources of Danger No danger originates from the measuring system itself, if it is properly installed and commissioned.

All persons working on the measuring system are required to observe the safety hints and know the parts of the technical documentation relevant to their work. ATEX Zone 1 6. The optional memory expansion provided by the USB stick makes the device ideal for even more extensive applications. Installing Fieldbus Interface Fig. The PC board is equipped with two bus connectors.


Every single data record includes the following values: Filling or discharge scales can also be easily combined at the same time. Interfaces Connectors Data Organization Data stored in the legal-for-trade memory cannot neither be manipulated nor loaded down with the use of standard tools. The terminal is more efficient, extremely adaptable, highly gersus and sustainable, delivering the very best solution for complex tasks. Sustainable in all regards: To ensure the high degree of protection: Please note that the first and the last station on CAN bus must be equipped with a bus terminator.

For 12Mbaud, the following physical restriction additionally applies: For activation, single inputs are reset to zero: Before performing work on the electrical equipment, disconnect the power supply.


Connect and supply the DT control terminal in the safe area as shown in wiring diagram on page The following search criteria are possible: This type is a variant of stainless steel unit VKG adjusted to explosion protection requirements.

Personnel Preparation, installation, commissioning, operation, maintenance, and fisomat may exclusively be performed by skilled persons only.

Maximum transmission rate is 10MBaud. Set baud rate and station address of the device in the dialog mode. RS and RS can be used as alternative only 1 physical interface.


Parametrize interface as follows: To do so, set jumper W on device to position Fieldbox VFG The fixing elements are supplied. If the scale does not yield the expected results, or weight value is unstable, we recommend to check load cell supply.


CET Service specialists are available to you in every department during our normal office hours for analying problems and malfunctions. We use cookies our own and those of third parties to make it easier for you to use our websites.

Perform parameterization and calibration as described in the Operating manual. When using an ICPthis type of circuitry is highly recommended. For itemssee Fig. No special jumper position must be observed. This means that the operation from the PC keyboard is exactly the same as on the device direct.

VVG is used if no control or maanual unit is provided but interfaces or binary signals are required locally. Secondary Displays This page has been left empty intentionally. Remove separator plate, and the connector board is exposed. Interfaces Connectors Figure Other benefits at a glance: Further information about the cookies used. Connection takes place across connector XE1 using a standard network cable with plug RJ When used in dust explosive atmospheres, the type of protection is essential for the compliance with the explosion protection requirements.

The individual Z barriers are equipped with an exchangeable preliminary fuse.